Multipoint (weld-in) roll cage:

These have a minimum of 8 point attachments.

Please note, HOWEVER – Because our roll cage will fit very closely to the body-shell it would be normal practice to weld the cage to the shell in at least an additional 8 or 10 places, (and sometimes many more) making a minimum of 16 points.

Weld-in roll cage kit:

Our weld-in kits are supplied with all the parts you need to fit a roll cage.

All the tubes are pre-cut and profiled to fit.

They come complete with the footplates that get welded to the car, as well as all relevant gussets.

FIA Certificated Cages:

Fully certificated roll-cage designs give a distinct advantage over roll-cages constructed to minimum compliance as they are constructed using a small diameter / thinner gauge tube, thus giving a considerable weight saving.

Depending on the make & model, a fully certificated roll cage gives you the ability to compete in FIA International events and feature the following:

• A certificated design is manufactured to meet the FIA / MSUK Roll Cage Homologation Regulations.
• Usually, a ‘Multi-point’ design which adds stiffness and strength to the bodyshell.
• These are almost always a ‘weld-in’ cage which is lighter and stiffer than a ‘bolt-in’ cage.
• The designs are stress tested to prove their integrity and geometry, and tube sizes are optimised to give the best strength-to-weight ratio.
• We always use high-tensile tube for these designs (normally T45, which has a tensile strength of min. 700 Mpa) to further enhance their advantages.
• An FIA / MSUK certificated roll cage is accepted worldwide and enables competitors to run in any FIA-sanctioned event.
• Can be as much as 20 kg lighter than an MSUK compliant design.
• When correctly installed, they add value and saleability to a vehicle.
• They are authorised in the UK by MSUK (the MSA as was), but the certificates are still referred to as FIA papers.
• These regulations are constantly evolving, so new designs have to reflect these changes.

Please contact sales@customcages.co.uk for more details.

MSUK Compliant – See our ‘National’ range:

The roll cage will be made using the minimum MSUK prescribed tube sizes – thicker gauge than we would use in a certificated design, and, so (unfortunately) heavier.

Usually, these are manufactured from CDS (Cold Drawn Seamless) tube – ours is a high tensile material with a minimum tensile strength of 510 Mpa – although T45 can be specified at extra cost.

These cages are eligible for all MSUK events.